Administrator Guide

17
Internet Group Management Protocol
(IGMP)
Internet group management protocol (IGMP) is supported on Dell Networking OS.
Multicast is premised on identifying many hosts by a single destination IP address; hosts represented by
the same IP address are a multicast group. IGMP is a Layer 3 multicast protocol that hosts use to join or
leave a multicast group. Multicast routing protocols (such as protocol-independent multicast [PIM]) use
the information in IGMP messages to discover which groups are active and to populate the multicast
routing table.
IGMP Implementation Information
• Dell Networking Operating System (OS) supports IGMP versions 1, 2, and 3 based on RFCs 1112, 2236,
and 3376, respectively.
• Dell Networking OS does not support IGMP version 3 and versions 1 or 2 on the same subnet.
• Dell Networking systems cannot serve as an IGMP host or an IGMP version 1 IGMP Querier.
• Dell Networking OS automatically enables IGMP on interfaces on which you enable a multicast
routing protocol.
IGMP Protocol Overview
IGMP has three versions. Version 3 obsoletes and is backwards-compatible with version 2; version 2
obsoletes version 1.
IGMP Version 2
IGMP version 2 improves on version 1 by specifying IGMP Leave messages, which allows hosts to notify
routers that they no longer care about traffic for a particular group.
Leave messages reduce the amount of time that the router takes to stop forwarding traffic for a group to
a subnet (leave latency) after the last host leaves the group. In version 1 hosts quietly leave groups, and
the router waits for a query response timer several times the value of the query interval to expire before it
stops forwarding traffic.
To receive multicast traffic from a particular source, a host must join the multicast group to which the
source is sending traffic. A host that is a member of a group is called a receiver. A host may join many
groups, and may join or leave any group at any time. A host joins and leaves a multicast group by sending
an IGMP message to its IGMP Querier. The querier is the router that surveys a subnet for multicast
receivers and processes survey responses to populate the multicast routing table.
IGMP messages are encapsulated in IP packets, as shown in the following illustration.
294
Internet Group Management Protocol (IGMP)