Administrator Guide

To enable the VRF feature and cause all VRF-related commands to be available or viewable in the CLI

interface, use the following command. You must enable the VRF feature before you can configure its

related attributes.

Dell(conf)# feature vrf

Based on whether VRF feature is identified as supported in the Feature Configuration file, configuration

command feature vrf becomes available for usage. This command will be stored in running-configuration

and will precede all other VRF-related configurations.

NOTE: The MXL and Z9000 platforms currently do not support VRF. These platforms support only

the management and default VRFs, which are available by default. As a result, the feature vrf

command is not available for these platforms.

To display the state of Dell Networking OS features:

Dell#show feature

Example of show feature output

For a particular target where VRF is enabled, the show output is similar to the following:

Feature State

------------------------------

VRF enabled

View Command History

The command-history trace feature captures all commands entered by all users of the system with a time

stamp and writes these messages to a dedicated trace log buffer.

The system generates a trace message for each executed command. No password information is saved

to the file.

To view the command-history trace, use the show command-history command.

Example of the show command-history Command

Dell#show command-history

[12/5 10:57:8]: CMD-(CLI):service password-encryption

[12/5 10:57:12]: CMD-(CLI):hostname Force10

[12/5 10:57:12]: CMD-(CLI):ip telnet server enable

[12/5 10:57:12]: CMD-(CLI):line console 0

[12/5 10:57:12]: CMD-(CLI):line vty 0 9

[12/5 10:57:13]: CMD-(CLI):boot system rpm0 primary flash://FTOS-

CB-1.1.1.2E2.bin

Upgrading Dell Networking OS

NOTE: To upgrade Dell Networking Operating System (OS), refer to the Release Notes for the

version you want to load on the system.

Getting Started