Administrator Guide

The following example creates a redirect list by the name of “xyz.”
Dell(conf)#ip redirect-list ?
WORD Redirect-list name (max 16 chars)
Dell(conf)#ip redirect-list xyz
Create a Rule for a Redirect-list
Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the redirect
list. You can enter the command multiple times and create a sequence of redirect rules. Use the
seq nn
redirect version of the command to organize your rules.
Command Syntax Command Mode Purpose
seq {number} redirect {ip-
address}{ip-protocol-
number | protocol-type
[bit]} {source mask | any |
host ip-address}
{destination mask | any |
host ip-address}
CONF-REDIRECT-LIST Configure a rule for the redirect list.
number is the number in sequence to initiate this
rule
ip-address is the Forwarding router’s address
FORMAT: A.B.C.D
FORMAT: slot/port
ip-protocol-number or protocol-type is the type
of protocol to be redirected
FORMAT: 0-255 for IP protocol number, or enter
protocol type
source ip-address or any or host ip-address is
the Source’s IP address
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
destination ip-address or any or host ip-address
is the Destination’s IP address
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
Delete a rule with the no redirect command.
The redirect rule supports Non-contiguous bitmasks for PBR in the
Destination router IP address
The below step shows a step-by-step example of how to create a rule for a redirect list by configuring:
• IP address of the next-hop router in the forwarding route
• IP protocol number
• Source address with mask information
• Destination address with mask information
Creating a Rule Example:
Dell(conf-redirect-list)#redirect ?
A.B.C.D Forwarding router's address
582
Policy-based Routing (PBR)