System information

Stacking PowerConnect 10G Switches: M8024-k, 8024, 8024F
43
unit image1 image2 current-active next-active
----- ------------ ------------ ----------------- -----------------
1 4.2.0.1 4.2.0.2 image1 image1
2 4.2.0.1 4.2.0.2 image1 image1
3 4.2.0.2 4.2.0.1 image2 image2
4 4.2.0.1 4.2.0.2 image1 image1
The current-active column now shows the same values as the next-active column. The next step is to
activate the image that contains the new firmware. In this example, Units 1, 2, and 4 will need
image2 activated, and Unit 3 will need image1 activated. Perform the following commands.
console#boot system 1 image2
Activating image image2 ..
console#boot system 2 image2
Activating image image2 ..
console#boot system 3 image1
Activating image image1 ..
console#boot system 4 image2
Activating image image2 ..
console#show version
Images currently available on Flash
unit image1 image2 current-active next-active
----- ------------ ------------ ----------------- -----------------
1 4.2.0.1 4.2.0.2 image1 image2
2 4.2.0.1 4.2.0.2 image1 image2
3 4.2.0.2 4.2.0.1 image2 image1
4 4.2.0.1 4.2.0.2 image1 image2
Notice the next-active column now shows different values than the current-active column.
Before performing the following update bootcode command, read the Release Notes and any special
instructions for updating the firmware release. It is generally required that you update bootcode only
on major releases of the firmware, whereas minor releases will not require the update to bootcode. It
is recommended to only run this command if required. Press Y when prompted.
console#update bootcode
Update bootcode and reset (Y/N)?Y
Issuing boot code update command... Validating boot code from image...CRC
Valid.
Updating and rebooting the stack will take a few minutes longer than a single switch. If the bootcode is
not required, then a simple reload command will need to be performed. After reload, the firmware
upgrade is complete.