Owner's manual
Table Of Contents
- Contents
- Your Dell Projector
- Connecting Your Projector
- Using Your Projector
- Turning Your Projector On
- Turning Your Projector Off
- Adjusting the Projected Image
- Adjusting the Projector Focus
- Adjusting Projection Image Size
- Using the Control Panel
- Using the Remote Control
- Installing the Remote Control Battery
- Operating Range with Remote Control
- Using the On-Screen Display
- Multimedia Introduction
- Photo Format
- Video Format
- Music Format
- How to set-up File Type for Multimedia with USB
- How to set-up File Type for Multimedia with SD Card
- How to set-up File Type for Multimedia with Internal Memory
- Office Viewer for the USB, SD, and Internal Memory
- Buttons Introduction
- Multimedia SETUP for USB, SD Card, and Internal Memory
- Intel® Wireless Display (WiDi) Installation
- Wi-Fi Display Installation
- Managing the Projector From Web Management
- Make Application Token
- Troubleshooting Your Projector
- Specifications
- Contacting Dell
- Appendix: Glossary
Problem (continued) Possible Solution (continued)
Image is reversed Select Projector Settings of the
Advanced Settings from the OSD and
adjust the projector mode.
Error LED is blinking amber A projector fan has failed and the
projector will automatically shut down.
TEMP LED is solid amber The projector has overheated. The display
automatically shuts down. Turn the
display on again after the projector cools
down. If the problem persists, contact
Dell.
TEMP LED is blinking
amber
If the projector fan fails, the projector will
automatically shut down. Clear the
projector mode by pressing and holding
the POWER button for 10 seconds. Please
wait for about 5 minutes and try to power
up again. If the problem persists, contact
Dell.
The OSD does not appear
on the screen
Press the Menu button on the panel for 15
seconds to unlock the OSD. Check the
Menu Lock on page 30.
The remote control is not
operating smoothly or
works only within a limited
range
The battery may be low. Check if the LED
indication from the remote is too dim. If
so, replace with a new CR2025 battery.
DoUSB not displaying Display over USB Should run
automatically. To manually run USB
display, go to My Computer and run
"USB_Display.exe".
NOTE: You may require
administrator level access to install
the driver. Contact your network
administrator for support.
Troubleshooting Your Projector 73