Reference Guide

set tag 34
!
Continue Clause
Normally, when a match is found, set clauses are executed, and the packet is then forwarded; no more route-map modules are
processed.
If you configure the continue command at the end of a module, the next module (or a specified module) is processed even
after a match is found. The following example shows a continue clause at the end of a route-map module. In this example, if a
match is found in the route-map “test” module 10, module 30 is processed.
NOTE: If you configure the continue clause without specifying a module, the next sequential module is processed.
Example of Using the continue Clause in a Route Map
!
route-map test permit 10
match commu comm-list1
set community 1:1 1:2 1:3
set as-path prepend 1 2 3 4 5
continue 30!
Access Control Lists (ACLs) 103