Reference Guide

Table 9. ETS Traffic Groupings (continued)
Traffic Groupings Description
Group bandwidth Percentage of available bandwidth allocated to a priority
group.
Group transmission selection algorithm (TSA) Type of queue scheduling a priority group uses.
In Dell Networking OS, ETS is implemented as follows:
ETS supports groups of 802.1p priorities that have:
PFC enabled or disabled
No bandwidth limit or no ETS processing
ETS uses the DCB MIB IEEE 802.1azd2.5.
Data Center Bridging Exchange Protocol (DCBx)
The data center bridging exchange (DCBx) protocol is disabled by default on the S4810; ETS is also disabled.
DCBx allows a switch to automatically discover DCB-enabled peers and exchange configuration information. PFC and ETS use
DCBx to exchange and negotiate parameters with peer devices. DCBx capabilities include:
Discovery of DCB capabilities on peer-device connections.
Determination of possible mismatch in DCB configuration on a peer link.
Configuration of a peer device over a DCB link.
DCBx requires the link layer discovery protocol (LLDP) to provide the path to exchange DCB parameters with peer devices.
Exchanged parameters are sent in organizationally specific TLVs in LLDP data units. The following LLDP TLVs are supported for
DCB parameter exchange:
PFC parameters
PFC Configuration TLV and Application Priority Configuration TLV.
ETS parameters ETS Configuration TLV and ETS Recommendation TLV.
Data Center Bridging in a Traffic Flow
The following figure shows how DCB handles a traffic flow on an interface.
Figure 27. DCB PFC and ETS Traffic Handling
204
Data Center Bridging (DCB)