Reference Guide

NOTE: Manually add the CAM-ACL space to the FCoE region as it is not applied by default.
To support FIP-Snooping and set CAM-ACL in the Z9500 switch, usecam-acl l2acl 4 ipv4acl 4 ipv6acl 0
ipv4qos 2 l2qos 1 l2pt 0 ipmacacl 0 vman-qos 0 ecfmacl 0 fcoeacl 2 iscsioptacl 0 command.
CAM ACL Table
-- Chassis Cam ACL --
Current Settings(in block sizes)
1 block = 128 entries
L2Acl : 4
Ipv4Acl : 4
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
VmanDualQos : 0
EcfmAcl : 0
FcoeAcl : 2
iscsiOptAcl : 0
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
nlbclusteracl: 0
st-sjc-s5000-29#
Enabling the FCoE Transit Feature
The following sections describe how to enable FCoE transit.
NOTE: FCoE transit is disabled by default. To enable this feature, you must follow the Configure FIP Snooping.
As soon as you enable the FCoE transit feature on a switch-bridge, existing VLAN-specific and FIP snooping configurations are
applied. The FCoE database is populated when the switch connects to a converged network adapter (CNA) or FCF port and
compatible DCB configurations are synchronized. By default, all FCoE and FIP frames are dropped unless specifically permitted
by existing FIP snooping-generated ACLs. You can reconfigure any of the FIP snooping settings.
If you disable FCoE transit, FIP and FCoE traffic are handled as normal Ethernet frames and no FIP snooping ACLs are
generated. The VLAN-specific and FIP snooping configuration is disabled and stored until you re-enable FCoE transit and the
configurations are re-applied.
Enable FIP Snooping on VLANs
You can enable FIP snooping globally on a switch on all VLANs or on a specified VLAN.
When you enable FIP snooping on VLANs:
● FIP frames are allowed to pass through the switch on the enabled VLANs and are processed to generate FIP snooping ACLs.
● FCoE traffic is allowed on VLANs only after a successful virtual-link initialization (fabric login FLOGI) between an ENode and
an FCF. All other FCoE traffic is dropped.
● You must configure at least one interface for FCF (FCoE Forwarder) mode on a FIP snooping-enabled VLAN. You can
configure multiple FCF trusted interfaces in a VLAN.
● A maximum of eight VLANS are supported for FIP snooping on the switch. When enabled globally, FIP snooping processes
FIP packets in traffic only from the first eight incoming VLANs. When enabled on a per-VLAN basis, FIP snooping is
supported on up to eight VLANs.
290
FCoE Transit