Reference Guide

IPV6 is enabled
Link Local address: fe80::201:e8ff:fe8b:7570
Global Unicast address(es):
1212::12, subnet is 1212::/64 (MANUAL)
Remaining lifetime: infinite
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:12
ff02::1:ff8b:7570
ND MTU is 0
ICMP redirects are not sent
DAD is enabled, number of DAD attempts: 3
ND reachable time is 20120 milliseconds
ND base reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 198 to 600 seconds
ND router advertisements live for 1800 seconds
ND advertised hop limit is 64
IPv6 hop limit for originated packets is 64
ND dns-server address is 1000::1 with lifetime of 1 seconds
ND dns-server address is 3000::1 with lifetime of 1 seconds
ND dns-server address is 2000::1 with lifetime of 0 seconds
To display IPv6 RDNSS information, use the show configuration command in INTERFACE CONFIG mode.
Dell(conf-if-te-0/1)#show configuration
The following example uses the show configuration command to display IPv6 RDNSS information.
!
interface TenGigabitEthernet 0/1
no ip address
ipv6 address 1212::12/64
ipv6 nd dns-server 1000::1 1
ipv6 nd dns-server 3000::1 1
ipv6 nd dns-server 2000::1 0
no shutdown
Secure Shell (SSH) Over an IPv6 Transport
Both inbound and outbound secure shell (SSH) sessions using IPv6 addressing are supported.
Inbound SSH supports accessing the system through the management interface as well as through a physical Layer 3 interface.
For SSH configuration details, refer to the Security chapter in the Dell Networking OS Command Line Interface Reference
Guide.
Configuration Tasks for IPv6
The following are configuration tasks for the IPv6 protocol.
● Adjusting Your CAM-Profile
● Assigning an IPv6 Address to an Interface
● Assigning a Static IPv6 Route
● Configuring Telnet with IPv6
● SNMP over IPv6
● Showing IPv6 Information
● Clearing IPv6 Routes
392
IPv6 Routing