Reference Guide

L fe80::/10 [0/0]
Direct, Nu 0, 00:34:42
Dell#show ipv6 route static
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
S 8888:9999:5555:6666:1111:2222::/96 [1/0]
via 2222:2222:3333:3333::1, Te 9/1, 00:03:16
S 9999:9999:9999:9999::/64 [1/0]
via 8888:9999:5555:6666:1111:2222:3333:4444, 00:03:16
Displaying the Running Configuration for an Interface
To view the configuration for any interface, use the following command.
● Display the currently running configuration for the specified interface.
EXEC mode
show running-config interface type {slot/port}
Enter the keyword interface then the type of interface and slot/port information:
○ For the management interface, enter the keyword ManagementEthernet 0/0.
○ For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
○ For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
Dell#show run int te 2/2
!
interface TenGigabitEthernet 2/2
no ip address
ipv6 address 3:4:5:6::8/24
shutdown
Dell#
Clearing IPv6 Routes
To clear routes from the IPv6 routing table, use the following command.
● Clear (refresh) all or a specific route from the IPv6 routing table.
EXEC mode
clear ipv6 route {* | ipv6 address prefix-length}
○ *: all routes.
○ ipv6 address: the format is x:x:x:x::x.
○ mask: the prefix length is from 0 to 128.
NOTE:
IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is separated
by a colon (:). Omitting zeros is accepted as described in Addressing.
IPv6 Routing 397