Reference Guide

May 12 12:20:42: Dell#: %CLI-6-service timestamps log datetime by admin from vty0
(10.14.1.98)
For information about the logging extended command, see Enabling Audit and Security Logs
Example of the show logging Command for Security
Dell#show logging
Jun 10 04:23:40: %STKUNIT0-M:CP %SEC-5-LOGIN_SUCCESS: Login successful for user admin
on line vty0 ( 10.14.1.91 )
Clearing Audit Logs
To clear audit logs, use the clear logging auditlog command in Exec mode. When RBAC is enabled, only the system
administrator user role can issue this command.
Example of the clear logging auditlog Command
Dell# clear logging auditlog
Configuring Logging Format
To display syslog messages in a RFC 3164 or RFC 5424 format, use the logging version [0 | 1} command in
CONFIGURATION mode. By default, the system log version is set to 0.
The following describes the two log messages formats:
● 0 – Displays syslog messages format as described in RFC 3164, The BSD syslog Protocol
● 1 – Displays syslog message format as described in RFC 5424, The SYSLOG Protocol
Example of Configuring the Logging Message Format
Dell(conf)#logging version ?
<0-1> Select syslog version (default = 0)
Dell(conf)#logging version 1
52
Switch Management