Reference Guide

no ip address
dot1x authentication
no shutdown
!
Dell#
View 802.1X configuration information for an interface using the show dot1x interface command.
The bold lines show that 802.1X is enabled on all ports unauthorized by default.
Dell#show dot1x interface TenGigabitEthernet 2/1
802.1x information on Te 2/1:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: UNAUTHORIZED
Re-Authentication: Disable
Untagged VLAN id: None
Guest VLAN: Disable
Guest VLAN id: NONE
Auth-Fail VLAN: Disable
Auth-Fail VLAN id: NONE
Auth-Fail Max-Attempts: NONE
Mac-Auth-Bypass: Disable
Mac-Auth-Bypass Only: Disable
Tx Period: 30 seconds
Quiet Period: 60 seconds
ReAuth Max: 2
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 2
Host Mode: SINGLE_HOST
Auth PAE State: Initialize
Backend State: Initialize
Configuring Request Identity Re-Transmissions
If the authenticator sends a Request Identity frame, but the supplicant does not respond, the authenticator waits 30 seconds
and then re-transmits the frame.
The amount of time that the authenticator waits before re-transmitting and the maximum number of times that the
authenticator re-transmits are configurable.
NOTE:
There are several reasons why the supplicant might fail to respond; for example, the supplicant might have been
booting when the request arrived or there might be a physical layer problem.
To configure re-transmissions, use the following commands.
● Configure the amount of time that the authenticator waits before re-transmitting an EAP Request Identity frame.
INTERFACE mode
dot1x tx-period number
The range is from 1 to 65535 (1 year)
The default is 30.
● Configure a maximum number of times the authenticator re-transmits a Request Identity frame.
INTERFACE mode
dot1x max-eap-req number
The range is from 1 to 10.
The default is 2.
The example in Configuring a Quiet Period after a Failed Authentication shows configuration information for a port for which the
authenticator re-transmits an EAP Request Identity frame after 90 seconds and re-transmits a maximum of 10 times.
72
802.1X