Reference Guide
○ For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
○ For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
○ For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
To view the configuration, use the show running-config ntp command in EXEC privilege mode (refer to the example in
Configuring NTP Authentication).
Configuring NTP Authentication
NTP authentication and the corresponding trusted key provide a reliable means of exchanging NTP packets with trusted time
sources.
NTP authentication begins when the first NTP packet is created following the configuration of keys. NTP authentication in Dell
Networking OS uses the message digest 5 (MD5) algorithm and the key is embedded in the synchronization packet that is sent
to an NTP time source.
Dell Networking OS Behavior: Dell Networking OS uses an encryption algorithm to store the authentication key that is
different from previous Dell Networking OS versions; Dell Networking OS uses data encryption standard (DES) encryption to
store the key in the startup-config when you enter the ntp authentication-key command. Therefore, if your system
boots with a startup-configuration from an Dell Networking OS version in which you have configured ntp authentication-
key, the system cannot correctly decrypt the key and cannot authenticate the NTP packets. In this case, re-enter this
command and save the running-config to the startup-config.
To configure NTP authentication, use the following commands.
1. Enable NTP authentication.
CONFIGURATION mode
ntp authenticate
2. Set an authentication key.
CONFIGURATION mode
ntp authentication-key number md5 key
Configure the following parameters:
● number: the range is from 1 to 4294967295. This number must be the same as the number in the ntp trusted-key
command.
● key: enter a text string. This text string is encrypted.
3. Define a trusted key.
CONFIGURATION mode
ntp trusted-key number
Configure a number from 1 to 4294967295.
The number must be the same as the number used in the ntp authentication-key command.
4. Configure an NTP server.
CONFIGURATION mode
ntp server [vrf] <vrf-name> {hostname | ipv4-address |ipv6-address} [ key keyid] [prefer]
[version number]
Configure the IP address of a server and the following optional parameters:
● ○ vrf-name : Enter the name of the VRF through which the NTP server is reachable.
○ hostname : Enter the keyword hostname to see the IP address or host name of the remote device.
○ ipv4-address : Enter an IPv4 address in dotted decimal format (A.B.C.D).
○ ipv6-address : Enter an IPv6 address in the format 0000:0000:0000:0000:0000:0000:0000:0000. Elision of zeros
is supported.
○ key keyid : Configure a text string as the key exchanged between the NTP server and the client.
○ prefer: Enter the keyword prefer to set this NTP server as the preferred server.
○ version number : Enter a number as the NTP version. The range is from 1 to 4.
5. Configure the switch as NTP master.
CONFIGURATION mode
746
System Time and Date