Reference Guide

Table 69.
Feature/Capability Support Status for Default VRF Support Status for Non-default VRF
Configuration rollback for commands
introduced or modified
Yes No
LLDP protocol on the port Yes No
802.1x protocol on the VLAN port Yes No
OSPF, RIP, ISIS, BGP on physical and
logical interfaces
Yes Yes
NOTE: OSPF supported on all VRF
ports. OSPF V2 and BGP V4 are
supported on non-default-VRF ports
also. Others supported only on
default-VRF ports.
Dynamic Port-channel (LACP) on VLAN
port or a Layer 3 port
Yes Yes
Static Port-channel as VLAN port or a
Layer 3 port
Yes Yes
Port-monitoring Yes No
BFD on physical and logical interfaces Yes No
PVST, MSTP, RSTP and 802.1D STP for
VLANs
Yes No
FRRP (if applicable) for VLANs Yes No
Multicast protocols (PIM-SM, PIM-DM,
MSDP)
Yes No
Layer 3 (IPv4/IPv6) ACLs, TraceLists,
PBR, QoS on VLANs
Yes Yes
NOTE: ACLs supported on all VRF
VLAN ports. IPv4 ACLs are
supported on non-default-VRFs also.
IPv6 ACLs are supported on default-
VRF only. PBR supported on default-
VRF only. QoS not supported on
VLANs.
Layer 3 (IPv4/IPv6) ACLs, TraceLists,
PBR, QoS on physical interfaces and
LAGs
Yes No
IPv4 ARP Yes Yes
IPv6 Neighbor Discovery Yes Yes
Layer 2 ACLs on VLANs Yes No
FEED Yes No
Layer 2 QoS Yes Yes
Support for storm-control (broadcast
and unknown-unicast)
Yes No
sFlow Yes No
VRRP on physical and logical interfaces Yes Yes
VRRPV3 Yes Yes
Secondary IP Addresses Yes No
Following IPv6 capabilities No
Virtual Routing and Forwarding (VRF) 775