Reference Guide

The following example shows the advertise-interval command configured in seconds.
Dell(conf-if-te-1/1)#vrrp-group 111
Dell(conf-if-te-1/1-vrid-111)#advertise-interval 10
Dell(conf-if-te-1/1-vrid-111)#
The following example shows the advertise-interval command configured in 1000 centisecs.
Dell(conf-if-te-1/1)#vrrp-group 111
Dell(conf-if-te-1/1-vrid-111)#version 3
Dell(conf-if-te-1/1-vrid-111)#advertise-interval centisecs 1000
Dell(conf-if-te-1/1-vrid-111)#
NOTE:
To verify the advertise-interval setting, use the show conf command.
Dell(conf-if-te-1/1-vrid-111)#show conf
!
vrrp-group 111
advertise-interval 10
authentication-type simple 7 387a7f2df5969da4
no preempt
priority 255
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
virtual-address 10.10.10.10
Dell(conf-if-te-1/1-vrid-111)#
Track an Interface or Object
You can set the system to monitor the state of any interface according to the virtual group.
Each VRRP group can track up to 12 interfaces and up to 20 additional objects, which may affect the priority of the VRRP
group. If the tracked interface goes down, the VRRP group’s priority decreases by a default value of 10 (also known as cost). If
the tracked interface’s state goes up, the VRRP group’s priority increases by 10.
The lowered priority of the VRRP group may trigger an election. As the Master/Backup VRRP routers are selected based on the
VRRP group’s priority, tracking features ensure that the best VRRP router is the Master for that group. The sum of all the costs
of all the tracked interfaces must be less than the configured priority on the VRRP group. If the VRRP group is configured as
Owner router (priority 255), tracking for that group is disabled, irrespective of the state of the tracked interfaces. The priority
of the owner group always remains at 255.
For a virtual group, you can track the line-protocol state or the routing status of any of the following interfaces:
● 10-Gigabit Ethernet: enter tengigabitethernet slot/port.
● 40-Gigabit Ethernet: enter fortyGigE slot/port.
● Port channel: enter port-channel number.
● VLAN: enter vlan vlan-id. Valid VLAN IDs are from 1 to 4094.
For a virtual group, you can also track the status of a configured object by entering its object number.
NOTE:
You can configure a tracked object for a VRRP group (using the track object-id command in INTERFACE-
VRID mode) before you actually create the tracked object (using a track object-id command in CONFIGURATION
mode). However, no changes in the VRRP group’s priority occur until the tracked object is defined and determined to be
down.
In addition, if you configure a VRRP group on an interface that belongs to a VRF instance and later configure object tracking on
an interface for the VRRP group, the tracked interface must belong to the VRF instance.
844
Virtual Router Redundancy Protocol (VRRP)