Reference Guide

This time is the gap between system boot up completion and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
Sample Configurations
Before you set up VRRP, review the following sample configurations.
VRRP for an IPv4 Configuration
The following configuration shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and is
intended to provide guidance for only a typical VRRP configuration. You can copy and paste from the example to your CLI. To
support your own IP addresses, interfaces, names, and so on, be sure that you make the necessary changes. The VRRP topology
was created using the CLI configuration shown in the following example.
Figure 131. VRRP for IPv4 Topology
Virtual Router Redundancy Protocol (VRRP)
847