Installation manual
Label LED Color/
Display
Description
Management port status LED
• Off
• Green solid
• Port is Down
• Traffic on Management Port
Figure 4. 40GbE Port LEDs (I/O Panel)
1. Port LED
NOTE: In 40GbE mode, the front end ports are “solid green” color in operational state. However, if
the port is configured to work in 10GbE mode, then the front end ports are “solid amber” color in
operational state.
NOTE: The four 10GbE ports split from a single 40GbE port share the same locator LED as the
40GbE port. Use the CLI system location-led interface fortyGigE /tengigabitethernet SLOT/PORT on
command to locate the 10GbE/40GbE port and then press the channel selector button to locate
the corresponding 10GbE port as shown in Figure 3. When port locator functionality is enabled on a
port - the corresponding port LED turns solid blue.
Table 2. 40GbE Port LEDs
Label LED Color/Display Description
Port locator LED
• Off
• Blue
• No activity
• Port locator
Port link/activity LED
• Off
• Green solid
• Green blinking
• Amber solid
• Amber blinking
• No link or interface disabled
• 40GbE link present and interface enabled
• Port has activity
• 10GbE link present and interface enabled
• 10GbE port has activity
12
Hardware Overview