Installation manual

Installing the Z9500 in a Rack Enclosure with No Front Door

1. Top view of rack enclosure (for example, Dell

4226 – 1070 mm cabinet)

2. Front door has been removed.

When you install the Z9500 switch in a 1070 mm rack enclosure in which the front door must be closed,

either leave the back door open or remove the back door. Then follow these steps.

1. Re-position and fasten the front rack posts (vertical rails) 6 inches back towards the rear of the rack

(as shown in the next figure).

2. Lift the chassis, align it with the rails installed in the rack, and slide the chassis into the rack. The front

I/O panel of the chassis should be flush with the front vertical rails and sit 6 inches back from the

front door. There should be sufficient space to attach QSFP+ optics and cables to the front I/O

panel.

Z9500 Installation