Installation manual

Figure 9. Connecting AC Power Supply Cords

1. AC3 Prong

NOTE: The system is powered-up as soon as you connect the power cord between the system

and the power source.

CAUTION: Always disconnect the power cable before you service the power supply slots.

CAUTION: Use the power supply cord as the main disconnect device on the AC system.

Ensure that the socket-outlet is located/installed near the equipment and is easily accessible.

4. Repeat steps 1 through 3 above for all PSUs.

NOTE: Ensure that the PSU is correctly installed. When you correctly install the PSU, the power

connector is on the left side of the PSU.

Securing Power Cables

1. Bend the system power cables, as shown in the following illustration, and attach to the cable clasp.

NOTE: Install all four PSUs before securing the power cables.

Z9500 Installation