Switch User Manual

IPv6 Routing Commands 1021
no ipv6 mld router
Default Configuration
MLD is disabled by default.
Command Mode
Global Configuration mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld router
ipv6 mtu
Use the ipv6 mtu command in Interface Configuration mode to set the
maximum transmission unit (MTU) size, in bytes, of IPv6 packets on an
interface. This command replaces the default MTU with a new MTU value.
The IPv6 MTU is only observed for packets originating on the switch. Packets
forwarded by the hardware ignore the IPv6 MTU.
Syntax
ipv6 mtu < bytes >
no ipv6 mtu
Parameter Description
Parameter Description
bytes The maximum transmission size of an IPv6 frame. (Range:
1280-1500)
2CSPC4.XCT-SWUM2XX1.book Page 1021 Monday, October 3, 2011 11:05 AM