Switch User Manual

1144 OSPF Commands
Default Configuration
Passive interface mode is disabled by default.
Command Mode
Router OSPF Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface vlan 1
redistribute
Use the redistribute command in Router OSPF Configuration mode to
configure OSPF protocol to allow redistribution of routes from the specified
source protocol/routers. Use the no version of the command to disable
redistribution from the selected source or to reset options to their default
values.
Syntax
redistribute protocol [metric metric-value] [metric-type type-value] [tag
tag-value] [subnets]
no redistribute protocol [metric] [metric-type] [tag] [subnets]
Parameter Description
Parameter Description
protocol rip - Specifies RIP as the source protocol.
static - Specifies that the source is a static route.
connected - Specifies that the source is a directly connected
route.
static Specifies that the source is a static route.
connected Specifies that the source is a directly connected route.
2CSPC4.XCT-SWUM2XX1.book Page 1144 Monday, October 3, 2011 11:05 AM