Switch User Manual

1610 System Management Commands
show slot
Use the show slot command in User EXEC mode to display information
about all the slots in the system or for a specific slot.
Syntax
show slot [ slot/port ]
The following table explains the output parameters.
If you supply a value for slot/port, the following additional information
appears as shown in the table below.
Field Description
Connection Connection number
Host Remote host to which the switch is connected
through a Telnet session
Address IP address of the remote host
Port Telnet TCP port number
Parameter Description
Slot The slot identifier in a slot/port format.
Slot Status The slot is empty, full, or has encountered
an error.
Admin State The slot administrative mode is enabled
or disabled.
Power State The slot power mode is enabled or
disabled.
Configured Card Model Identifier The model identifier of the card
preconfigured in the slot. Model identifier
is a 32-character field used to identify a
card.
Pluggable Cards are pluggable or non-pluggable in
the slot.
2CSPC4.XCT-SWUM2XX1.book Page 1610 Monday, October 3, 2011 11:05 AM