Switch User Manual

654 QoS Commands
Syntax
classofservice trust {dot1p | untrusted | ip-dscp}
no classofservice trust
• dot1p — Specifies that the mode be set to trust dot1p (802.1p) packet
markings.
•
untrusted — Sets the Class of Service Trust Mode for all interfaces to
Untrusted.
•
ip-dscp — Specifies that the mode be set to trust IP DSCP packet
markings.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode or Interface Configuration (gigabitethernet,
port-channel, tengigabitethernet) mode
User Guidelines
This command has no user guidelines.
Examples
The following example displays how you set the class of service trust mode of
an interface to trust dot1p (802.1p) packet markings when in Global
Configuration mode.
console(config)#classofservice trust dot1p
The following example displays how you set the class of service trust mode of
an interface to trust IP Precedence packet mark
console(config)#classofservice trust ip-precedence
conform-color
Use the conform-color command in Policy-Class-Map Configuration mode
to specify second-level matching for traffic flow, the only possible actions are
drop, setdscp-transmit, set-prec-transmit, or transmit. In this two-rate form
2CSPC4.XCT-SWUM2XX1.book Page 654 Monday, October 3, 2011 11:05 AM