Switch User Manual

IPv6 PIM Commands 1007
If no RP Group mapping exist on the router, the following message is
displayed:
No RP-Group mappings exist/learnt on this router.
show ipv6 pim rp mapping
Use the show ipv6 pim rp mapping command to display the mappings for the
PIM group to the active Rendezvous Points (RPs).
Syntax
show ipv6 pim rp mapping [ rp-address ]
Parameter Description
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
There are no user guidelines for this command. Field descriptions are shown
in the following table.
Example
(console) # show ipv6 pim rp mapping candidate
Parameter Description
rp-address IP address of the RP
Field Description
RP Address Address of the RP
Group Address Address of the multicast group
Origin Origin from where this group mapping is learned
2CSPC4.XCT-SWUM2XX1.book Page 1007 Monday, October 3, 2011 11:05 AM