Switch User Manual

IPv6 Routing Commands 1009
50
IPv6 Routing Commands
The IPv6 version of the routing table manager provides a repository for IPv6
routes learned by dynamic routing protocols or static configuration. RTO6
manages dynamic and static IPv6 routes, redistributes routes to registered
protocols, supports ECMP routes, and supports multiple routes to the same
destination, sorted by preference. IPv6 routing only operates over VLAN
interfaces.
IPv6 Limitations & Restrictions
The following limitations apply:
• IPSec support is not available.
• The DHCPv6 server does not support stateful address configuration.
• Automated router renumbering is not supported.
• IPv6 is not supported on the service port.
Commands in this Chapter
This chapter explains the following commands:
clear ipv6
neighbors
ipv6 mld query-
max-response-time
ipv6 route show ipv6 mld-proxy
groups detail
clear ipv6 statistics ipv6 mld router ipv6 route distance show ipv6 mld-proxy
interface
ipv6 address ipv6 mtu ipv6 unicast-
routing
show ipv6 mld traffic
ipv6 enable ipv6 nd dad
attempts
ping ipv6 show ipv6 neighbors
ipv6 hop-limit ipv6 nd managed-
config-flag
ping ipv6 interface show ipv6 route
ipv6 host ipv6 nd ns-interval show ipv6 brief show ipv6 route
preferences
2CSPC4.XCT-SWUM2XX1.book Page 1009 Monday, October 3, 2011 11:05 AM