Switch User Manual

1032 IPv6 Routing Commands
the distance of existing static routes, even if they were assigned the original
default distance. The new default distance is applied to static routes created
after invoking the ipv6 route distance command.
Syntax
ipv6 route distance integer
no ipv6 route distance
integer
• integer — Specifies the distance (preference) of an individual static route.
(Range 1-255)
Default Configuration
Default value of integer is 1.
Command Mode
Global Configuration mode
User Guidelines
Lower route distance values are preferred when determining the best route.
Example
The following example sets the default distance to 80.
console(config)#ipv6 route distance 80
ipv6 unicast-routing
Use the ipv6 unicast-routing command in Global Configuration mode to
enable forwarding of IPv6 unicast datagrams.
Syntax
ipv6 unicast-routing
no ipv6 unicast-routing
Default Configuration
Disabled is the default configuration.
2CSPC4.XCT-SWUM2XX1.book Page 1032 Monday, October 3, 2011 11:05 AM