Switch User Manual

IPv6 Routing Commands 1061
Syntax
traceroute ipv6 { ip-address | hostname } [ port ]
• ipv6-address — Destination IPv6 address.
•
hostname — Hostname to ping (contact). (Range: 1–158 characters). The
command allows spaces in the host name when specified in double quotes.
For example,
console(config)#traceroute "host name"
• port — UDP port used as the destination of packets sent as part of the
traceroute. This port should be an unused port on the destination system.
(Range: 0–65535)
Default Configuration
33434 is the default port value.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example discovers the packet routes on a hop-by-hop basis.
console#traceroute ipv6 2020:1::1
Tracing route over a maximum of 20 hops
1 * N * N * N
2CSPC4.XCT-SWUM2XX1.book Page 1061 Monday, October 3, 2011 11:05 AM