Switch User Manual

1102 OSPF Commands
Default Configuration
10 is the default configuration for integer .
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example identifies a stub area of 10 and default cost of 100.
console(config)#router ospf
console(config-router)#area 10 default-cost 100
area nssa (Router OSPF)
Use the area nssa command in Router OSPF Configuration mode to
configure the specified area ID to function as an NSSA. If the area has not
been previously created, this command creates the area and then applies the
NSSA distinction. If the area already exists, the NSSA distinction is added or
modified. Use the no form of the command to remove the NSSA distinction
from the specified area ID.
Syntax
area area-id nssa [no-redistribution] [default-information-originate [metric
metric-value ] [metric-type metric-type-value ]] [no-summary] [translator-
role role] [translator-stab-intv interval]
no area
area-id nssa [no-redistribution] [default-information-originate] [no-
summary] [translator-role] [translator-stab-intv]
Parameter Description
Parameter Description
area-id Identifies the OSPF stub area to configure. (Range: IP address
or decimal from
0–4294967295)
2CSPC4.XCT-SWUM2XX1.book Page 1102 Monday, October 3, 2011 11:05 AM