Switch User Manual

112 Command Groups
switchport forbidden vlan Forbids adding specific VLANs to a port. IC
switchport general
acceptable-frame-type
tagged-only
Discards untagged frames at ingress. IC
switchport general allowed
vlan
Adds or removes VLANs from a port in General
mode.
IC
switchport general ingress-
filtering disable
Disables port ingress filtering. IC
switchport general pvid Configures the PVID when the interface is in
general mode.
IC
switchport mode Configures the VLAN membership mode of a
port.
IC
switchport trunk Adds or removes VLANs from a trunk port. IC
vlan Creates a VLAN. VLAN
vlan (Global Config) Configures a VLAN. GC
vlan association mac Associates a MAC address to a VLAN. VLAN
vlan association subnet Associates an IP subnet to a VLAN. VLAN
vlan database Enters the VLAN database configuration mode. GC
vlan makestatic Changes a dynamically created VLAN to a static
VLAN.
VLAN
vlan protocol group Adds protocol-based VLAN groups to the
system.
GC
vlan protocol group add
protocol
Adds a protocol to the protocol-based VLAN
identified by
groupid .
GC
vlan protocol group name Adds a group name to the protocol-based VLAN
identified by groupid .
GC
vlan protocol group remove Removes the protocol-base VLAN group
identified by groupid .
GC
vlan routing Enable routing on a VLAN. PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 79.
Command Description Mode
a
2CSPC4.XCT-SWUM2XX1.book Page 112 Monday, October 3, 2011 11:05 AM