Switch User Manual

1126 OSPF Commands
Syntax Description
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies the access list to filter routes received from
the RIP source protocol.
console(config-router)#distribute-list ACL40 out rip
enable
Use the enable command in Router OSPF Configuration mode to reset the
default administrative mode of OSPF in the router (active). Use the no form
of the command to disable the administrative mode for OSPF.
Syntax
enable
Parameter Description
name The name used to identify an existing ACL. The range is 1–31
characters.
rip Apply the specified access list when RIP is the source protocol.
static Apply the specified access list when packets come through the
static route.
connected Apply the specified access list when packets come from a
directly connected route.
2CSPC4.XCT-SWUM2XX1.book Page 1126 Monday, October 3, 2011 11:05 AM