Switch User Manual

1162 OSPF Commands
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the information for the IFO object or virtual
interface tables associated with VLAN 3.
console#show ip ospf interface vlan 10
IP Address..................................... 1.1.1.1
Subnet Mask................................. 255.255.255.0
Secondary IP Address(es).......................
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
OSPF Network Type.............................. Broadcast
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
Metric Cost.................................... 10 (computed)
Passive Status................................. Non-passive
interface
OSPF Mtu-ignore................................ Disable
State.......................................... designated-router
Designated Router.............................. 1.1.1.1
Backup Designated Router....................... 0.0.0.0
Number of Link Events.......................... 2
2CSPC4.XCT-SWUM2XX1.book Page 1162 Monday, October 3, 2011 11:05 AM