Switch User Manual

OSPFv3 Commands 1187
Default Configuration
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example creates the OSPF virtual interface for area 1 and its
neighbor router.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2
The following example configures a 20-second dead interval, a hello interval
of 20 seconds, a retransmit interval of 20 seconds, and a 20-second transmit
delay for the OSPF virtual interface on the virtual interface identified by area
1 and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 dead-
interval 20 hello-interval 20 retransmit-interval 20
transmit-delay 20
Parameter Default
area-id No area ID is predefined.
router-id No router ID is predefined.
hello-interval
seconds
10 seconds
retransmit-interval
seconds
5 seconds
transmit-delay
seconds
1 second
dead-interval
seconds
40 seconds
2CSPC4.XCT-SWUM2XX1.book Page 1187 Monday, October 3, 2011 11:05 AM