Switch User Manual

Captive Portal Commands 1317
protocol
Use the protocol command to configure the protocol mode for a captive
portal configuration.
Syntax
protocol { http | https }
Default Configuration
The default protocols mode is https.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#protocol http
redirect
Use the redirect command to enable the redirect mode for a captive portal
configuration. Use the “no” form of this command to disable redirect mode.
Syntax
redirect
no redirect
Default Configuration
Redirect mode is disabled by default.
Command Mode
Captive Portal Instance mode.
2CSPC4.XCT-SWUM2XX1.book Page 1317 Monday, October 3, 2011 11:05 AM