Switch User Manual

1592 System Management Commands
no motd-banner
• MESSAGE — Quoted text
Default Configuration
This command has no default configuration.
Command Mode
Line Configuration
User Guidelines
This command has no user guidelines.
Example
console(config-telnet)# motd-banner
nsf
Use this command to enable non-stop forwarding. The “no” form of the
command will disable NSF.
Syntax
nsf
no nsf
Default Configuration
Non-stop forwarding is enabled by default.
Command Mode
Stack Global Configuration mode
User Guidelines
Nonstop forwarding allows the forwarding plane of stack units to continue to
forward packets while the control and management planes restart as a result
of a power failure, hardware failure, or software fault on the stack
management unit.
2CSPC4.XCT-SWUM2XX1.book Page 1592 Monday, October 3, 2011 11:05 AM