Switch User Manual

1636 System Management Commands
Syntax
telnet { ip-address | hostname } [ port ] [ keyword1...... ]
Parameter Description
Keywords Table
Port Table
Parameter Description
ip-address Valid IP address of the destination host.
hostname Hostname of the destination host. (Range: 1–158 characters).
The command allows spaces in the host name when
specified in double quotes. For example,
console(config)#snmp-server host "host name"
port A decimal TCP port number, or one of the keywords from the
port table in the usage guidelines (see Port Table below).
keyword One or more keywords from the keywords table in the user
guidelines (see Keywords Table below).
Options Description
/debug Enable telnet debugging mode.
/line Enable telnet linemode.
/localecho Enable telnet localecho.
<cr> Press ENTER to execute the command.
port
Enter the port number. Refer to the following table.
Keyword Description Port Number
bgp Border Gateway Protocol 179
chargen Character generator 19
cmd Remote commands 514
daytime Daytime 13
discard Discard 9
2CSPC4.XCT-SWUM2XX1.book Page 1636 Monday, October 3, 2011 11:05 AM