Switch User Manual

294 Address Table Commands
Parameter Description
Default Configuration
No Multicast addresses are defined.
Command Mode
Global Configuration mode
User Guidelines
If the command is executed without add or remove, the command registers
only the group in the bridge database.
Static Multicast addresses can be defined only on static VLANs.
Examples
The following example registers the MAC address.
console(config)#mac address-table vlan 8 multicast
static 0100.5e02.0203
The following example registers the MAC address and adds ports statically.
console(config)#interface vlan 8
Parameter Description
add Adds ports to the group. If no option is specified, this is the
default option.
remove Removes ports from the group.
vlan
vlan-id Valid vlan ID (1-4093).
mac-multicast-
address
MAC multicast address in the format xxxx.xxxx.xxxx.
ip-multicast-address IP multicast address.
interface
interface-
list
Specify a comma separated list of interfaces, a range of
interfaces, or a combination of both. Interfaces can be port-
channel numbers or physical ports in unit/slot/port format.
2CSPC4.XCT-SWUM2XX1.book Page 294 Monday, October 3, 2011 11:05 AM