Switch User Manual

IP Addressing Commands 513
Use the no form of the command to remove a specific address or to return the
address assignment to its default value. Using the no form of the command
with no parameters removes all IPv6 prefixes from the interface.
Syntax
ipv6 address { prefix/prefix-length [eui64] | autoconfig | dhcp }
no ipv6 address {
prefix/prefix-length [eui64] | autoconfig | dhcp }
Parameter Description
Default Configuration
No address is assigned to the out-of-band interface by default.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
When DHCPv6 is enabled on the Out-of-Band interface, the system
automatically deletes all manually configured IPv6 addresses on the interface.
DHCPv6 can be enabled on the Out-of-Band interface only when IPv6 auto
configuration or DHCPv6 is not enabled on any of the in-band management
interfaces.
IPv6 auto configuration mode can be enabled in the Out-of-Band interface
only when IPv6 auto configuration or DHCPv6 is not enabled on any of the
in-band management interfaces.
Parameter Description
prefix An IPv6 prefix in global format address format.
eui64 Formulate the prefix in EUI-64 format.
autoconfig Perform IPv6 auto-configuration.
dhcp Obtain the prefix via DHCP.
2CSPC4.XCT-SWUM2XX1.book Page 513 Monday, October 3, 2011 11:05 AM