Switch User Manual

672 QoS Commands
• protocol-name — Specifies one of the supported protocol name keywords.
The supported values are
icmp , igmp , ip , tcp , and udp .
•
protocol-number — Specifies the standard value assigned by IANA.
(Range 0–255)
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition based on the "ip"
protocol name keyword.
console(config-classmap)#match protocol ip
match source-address mac
Use the match source-address mac command in Class-Map Configuration
mode to add to the specified class definition a match condition based on the
source MAC address of the packet.
Syntax
match source-address mac address macmask
• macaddr — Specifies any valid layer 2 MAC address formatted as six two-
digit hexadecimal numbers separated by colons.
•
macmask — Specifies a layer 2 MAC address bit mask formatted as six
two-digit hexadecimal numbers separated by colons. This bit mask does
not need to be contiguous.
Default Configuration
This command has no default configuration.
2CSPC4.XCT-SWUM2XX1.book Page 672 Monday, October 3, 2011 11:05 AM