Switch User Manual

862 ARP Commands
Default Configuration
This command has no default configuration.
Command Mode
User EXEC and Privileged EXEC modes
User Guidelines
The show arp command will display static (user-configured) ARP entries
regardless of whether they are reachable over an interface or not.
Example
The following example shows show arp command output.
console#show arp
Static ARP entries are only active
when the IP address is reachable on a local subnet
Age Time (seconds)............................. 1200
Response Time (seconds)........................ 1
Retries........................................ 4
Cache Size..................................... 6144
Dynamic Renew Mode ............................ Disable
Total Entry Count Current / Peak .............. 0 / 0
Static Entry Count Configured / Active / Max .. 1 / 0 / 128
IP Address MAC Address Interface Type Age
---------- -------------- --------- ------ -------
1.1.1.3 0000.0000.0022 n/a Static n/a
2CSPC4.XCT-SWUM2XX1.book Page 862 Monday, October 3, 2011 11:05 AM