Switch User Manual

IGMP Commands 931
Syntax
ip igmp robustness robustness
no ip igmp robustness
• robustness — Robustness variable. (Range: 1-255)
Default Configuration
The default robustness value is 2.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a robustness value of 10 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp robustness 10
ip igmp startup-query-count
Use the ip igmp startup-query-count command in Interface Configuration
mode to set the number of queries sent out on startup
—at intervals equal to
the startup query interval for the interface.
Syntax
ip igmp startup-query-count count
no ip igmp startup-query-count
• count — The number of startup queries. (Range: 1-20)
Default Configuration
The default count value is 2.
2CSPC4.XCT-SWUM2XX1.book Page 931 Monday, October 3, 2011 11:05 AM