Switch User Manual

994 IPv6 PIM Commands
ipv6 pim hello-interval
Use the ipv6 pim hello-interval command to administratively configure the
frequency of PIM Hello messages for the specified interface. Use the no form
of this command to return the configuration to the default.
Syntax
ipv6 pim hello-interval interval
no ipv6 pim hello-interval
Parameter Description
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(if-vlan-10)#ipv6 pim hello-interval 20
ipv6 pim join-prune-interval
Use the ipv6 pim join-prune-interval command to administratively configure
the frequency of join/prune messages on the specified interface. Use the no
form of this command to return the join/prune interval to the default.
Syntax
ipv6 pim join-prune-interval interval
Parameter Description
interval The number of seconds between successive hello transmissions.
Range 0-18000. Default 30.
2CSPC4.XCT-SWUM2XX1.book Page 994 Monday, October 3, 2011 11:05 AM