Switch User Manual

122 Ethernet Configuration Commands
www.dell.com | support.dell.com
• 1000 —Force 1000 Mbps operation.
•
10000 —Force 10000 Mbps operation.
Default Configuration
Maximum port capability.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
• The command " no speed " in port-channel context returns each port in the port-channel to its
maximum capability.
Example
The following example configures the speed operation of Ethernet g5 to force 100-Mbps operation.
duplex
The duplex Interface Configuration mode command configures the full/half duplex operation of a
given Ethernet interface when not using auto-negotiation. To restore the default, use the
no form
of this command.
Syntax
duplex { half | full }
no duplex
• half —Force half-duplex operation
•
full —Force full-duplex operation
Default Configuration
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
• Before attempting to force a particular duplex mode on the port operating at 10/100/1000
Mbps, disable the auto-negotiation on that port.
Console(config)# interface ethernet g5
Console(config-if)# speed 100