Switch User Manual

Ethernet Configuration Commands 137
Example
The following example displays the jumbo frames configuration.
port storm-control include-multicast
The port storm-control include-multicast Global Configuration mode command enables the
device to count multicast packets together with broadcast packets. To disable counting of multicast
packets, use the
no form of this command.
Syntax
port storm-control include-multicast
no port storm-control include-multicast
There are no arguments or keywords for this command.
Default Configuration
Multicast packets are not counted.
Command Modes
Global Configuration mode
User Guidelines
• To control multicasts storms use the commands port storm-control broadcast enable and
port storm-control broadcast rate .
Example
The following example enables the counting of multicast packets.
port storm-control broadcast enable
The port storm-control broadcast enable Interface Configuration mode command enables
broadcast storm control. To disable broadcast storm control, use the
no form of this command.
Syntax
port storm-control broadcast enable
Console# show ports jumbo-frame
Jumbo frames are disabled
Jumbo frames will be enabled after reset
Console# configure
Console(config)# port storm-control include-multicast