Switch User Manual

Line Commands 175
Syntax
exec-timeout minutes [ seconds ]
no exec-timeout
•
minutes —Integer that specifies the number of minutes. (Range: 0 - 65535)
•
seconds —Additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
• To specify no timeout, enter the exec-timeout ("0 0") command.
Examples
The following example configures the interval that the system waits until user input is detected to
20 minutes.
show line
The show line User EXEC mode command displays line parameters.
Syntax
show line [console | telnet | ssh ]
•
console —Console terminal line.
•
telnet —Virtual terminal for remote console access (Telnet).
•
ssh —Virtual terminal for secured remote console access (SSH).
Default Configuration
Default value is console .
Command Mode
User EXEC mode
User Guidelines
• There are no user guidelines for this command.
Console (config)# line console
Console(config-line)# exec-timeout 20