Switch User Manual

222 Radius Commands
www.dell.com | support.dell.com
Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the source IP address used for communication with RADIUS
servers to 10.1.1.1.
radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval for which a
device waits for a server host to reply. To restore the default, use the
no form of this command.
Syntax
radius-server timeout timeout
no radius-server timeout
• timeout —Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The default value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example sets the interval for which a device waits for a server host to reply to
5 seconds.
Console (config)# radius-server source-ip 10.1.1.1
Console (config)# radius-server timeout 5