Switch User Manual

30 Command Groups
www.dell.com | support.dell.com
LLDP Commands
speed Sets the line baud rate. Line
Configuration
autobaud
Sets the line for automatic baud rate detection Line
Configuration
exec-timeout Configures the interval that the system waits until
user input is detected.
Line
Configuration
show line Displays line parameters. User EXEC
Command Group Description Access Mode
lldp enable (global) Enables Link Layer Discovery Protocol. Global
configuration
lldp enable (interface) Enables Link Layer Discovery Protocol (LLDP) on an
interface.
Interface
configuration
(Ethernet)
lldp timer Specifies how often the software sends Link Layer
Discovery Protocol (LLDP) updates.
Global
configuration
lldp hold-multiplier Specifies the amount of time the receiving device should
hold a Link Layer Discovery Protocol packet before
discarding it.
Global
configuration
lldp reinit-delay Specifies the minimum time an LLDP port will wait
before reinitializing LLDP transmission.
Global
configuration
lldp tx-delay Specifies the delay between successive LLDP frame
transmissions initiated by value/status changes in the
LLDP local systems MIB.
Global
configuration
lldp optional-tlv Specifies which optional TLVs from the basic set should
be transmitted.
Interface
configuration
(Ethernet)
lldp management-
address
Specifies the management address that would be
advertised from an interface.
Interface
configuration
(Ethernet)
clear lldp rx Restarts the LLDP RX state machine and clears the
neighbors table.
Privileged
EXEC
show lldp
configuration
Displays the Link Layer Discovery Protocol (LLDP)
configuration.
Privileged
EXEC
show lldp local Displays the Link Layer Discovery Protocol (LLDP)
information that is advertised from a specific port.
Privileged
EXEC