Switch User Manual

Command Modes 47

logging file Limits syslog messages sent to the logging file based on severity.

logging on Controls error messages logging.

console.

management access-class Defines which management access-list is used.

management access-list Defines a management access-list, and enters the access-list for

configuration.

port jumbo-frame Enables jumbo frames for the device.

port storm-control include-

multicast

Enables the device to count multicast packets.

priority-queue out num-of-

queues

Enables the egress queues to be expedite queues.

qos Enables quality of service (QoS) on the device and enters QoS basic or

advance mode.

qos map dscp-queue Modifies the DSCP to CoS map.

qos trust (Global) Configure the system to "trust" state.

radius-server deadtime Improves RADIUS response times when servers are unavailable.

radius-server host Specifies a RADIUS server host.

radius-server key Sets the authentication and encryption key for all RADIUS

communications between the router and the RADIUS daemon.

radius-server retransmit Specifies the number of times the software searches the list of RADIUS

server hosts.

radius-server source-ip Specifies the source IP address used for communication with RADIUS

servers.

radius-server timeout Sets the interval for which a router waits for a server host to reply.

rmon alarm Configures alarm conditions.

rmon event Configures a RMON event.

rmon table-size Configures the maximum RMON tables sizes.

snmp-server community Sets up the community access string to permit access to SNMP

protocol.

snmp-server contact Sets up a system contact.

snmp-server enable traps Enables the switch to send SNMP traps or SNMP notifications.

snmp-server host

Specifies the recipient of Simple Network Management Protocol

notification operation

snmp-server location Sets up the information on where the device is located.