Switch User Manual

AAA Commands 73
Default Configuration
No password is required.
Command Mode
Line Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example specifies a password "secret" on a line.
enable password
The enable password Global Configuration mode command sets a local password to control access
to normal and privilege levels. To remove the password requirement, use the
no form of this
command.
Syntax
enable password [ level level ] password [ encrypted ]
no enable password [ level level ]
•
password —Password for this level, from 1 to 159 characters in length.
•
level level —Level for which the password applies. If not specified the level is 15
(Range: 1-15).
•
encrypted —Encrypted password entered, copied from another device configuration.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Console (config-line)# password secret