Owner's Manual

110 Clock
www.dell.com | support.dell.com
• hostname — Hostname of the server. (Range: 1-158 characters)
• poll — Enable polling.
•
keyid — Authentication key to use when sending packets to this peer.
(Range:1-4294967295)
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
User Guidelines
Up to 8 SNTP servers can be defined.
Use the
sntp unicast client enable global configuration command to enable Unicast clients
globally.
To enable polling globally, you should also use the
sntp unicast client poll global
configuration command.
Polling time is determined by the
sntp client poll timer global configuration command.
To define an SNTP server on the out-of-band port, use the out-of-band IP address format
oob / ip-address .
Examples
The following example configures the device to accept Simple Network Time Protocol (SNTP)
traffic from the server on 192.1.1.1.
show clock
The show clock user EXEC command displays the time and date from the system clock.
Syntax
show clock [detail]
• detail — Shows timezone and summertime configuration.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
Console(config)# sntp server 192.1.1.1