Owner's Manual
132 Ethernet Configuration Commands
www.dell.com | support.dell.com
Command Mode
Interface Configuration (Ethernet, port-channel, Out-of-Band Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example adds a description to the Ethernet g5.
speed
The
speed
interface configuration command configures the speed of a given Ethernet interface
when not using auto-negotiation. To restore the default, use the
no
form of this command.
Syntax
speed
{
10
|
100
|
1000
}
no speed
•
10
—Configures the port to 10 Mbps.
•
100
—Configures the port to 100 Mbps.
•
1000
—Configures the port to 1000 Mbps.
Default Configuration
Maximum port capability.
Command Mode
Interface Configuration (Ethernet, port-channel, Out-of-Band Ethernet) mode
User Guidelines
The command "
no speed
" in port-channel context returns each port in the port-channel to its
maximum capability.
Before attempting to force a particular duplex mode the port operating at 10/100 Mbps,
disable the auto-negotiation on that port.
Console(config)# interface ethernet g5
Console(config-if)# description RD_SW#3